91美女视频-亚洲免费观看视频-欧美a∨-久热在线视频-日韩黄网站-成av人片在线观看www-久操综合-超碰av在线播放-性欧美欧美巨大69-婷婷二区-av男人的天堂网-中文字幕一区在线播放-玖草在线观看-国产网址在线观看-免费在线不卡av

大家誰用codesys做過PID控制，可以共同討論一下(* PD controller *)
FUNCTION_BLOCK PID_FIXCYCLE
VAR_INPUT
    ACTUAL :REAL;        (* actual value, process variable *)
    SET_POINT:REAL;    (* desired value, set point *)
    KP:REAL;                (* proportionality const. (P)*)
    TN:REAL;                (* reset time (I) in sec *)
    TV:REAL;                (* rate time, derivative time (D) in sec*)
    Y_MANUAL:REAL;        (* Y is set to this value as long as MANUAL=TRUE *)
    Y_OFFSET:REAL;        (* offset for manipulated variable *)
    Y_MIN:REAL;            (* minimum value for manipulated variable *)
    Y_MAX:REAL;            (* maximum value for manipulated variable *)
    MANUAL:BOOL;        (*     TRUE: manual: Y is not influenced by controller,
                                FALSE: controller determines Y *)
    RESET:BOOL;            (* reset: set Y output to Y_OFFSET and reset integral part *)
    CYCLE:REAL;            (* time in s between two calls *)
END_VAR
VAR_OUTPUT
    Y:REAL;                (* manipulated variable, set value*)
    LIMITS_ACTIVE:BOOL:=FALSE;    (* true set value would exceed limits Y_MIN, Y_MAX *)
    OVERFLOW:BOOL:=FALSE;        (* overflow in integral part *)
END_VAR
VAR
    I: INTEGRAL;
    D: DERIVATIVE;
    TMDIFF: DWORD;
    ERROR: REAL;
    INIT: BOOL:=TRUE;
    Y_ADDOFFSET: REAL;
    KPcopy:REAL;
    TNcopy:REAL;
    TVcopy:REAL;
END_VAR

想穩定一個轉速   pid控制   速度可以通過脈沖進入plc    plc通過pwm口輸出來調節    使速度穩定到3000轉每分鐘